The common faults and troubleshooting of the winding packaging machine:
The indicator light is powered off:
- Power display: turn on the power switch;
- The indicator light is broken: replace the indicator light;
- The illustration is not plugged in properly: plugged in.
The turntable does not turn and run:
- The power is not turned on or phase is missing: check the power;
- Bad motor: replace the motor;
- The chain breaks or falls off: reinstall the chain;
- The control button is not good: replace;
- Adjust the frequency converter adjusting knob to the minimum position: adjust to the appropriate frequency;
- The emergency stop switch is at the stop position: turn on the emergency stop switch.
The lifting body on the mast does not lift:
- The limit switch is broken or the turntable counting formation switch is broken: replace;
- The power is not connected or phase is missing: check the power;
- The motor is broken: replace the motor;
- The chain is broken or stuck: replace;
- The elevator slider or PLG is broken: replace;
- Adjust the frequency converter adjusting knob at the minimum position: adjust to the appropriate frequency;
- The emergency stop switch is at the stop position: turn on the emergency stop switch.
Four-Stretch film break too often:
- The stretch film is broken or the quality is not good: replace;
- The pre-stretching motor is not good: replace the motor;
- The micro switch is broken or the tension spring is fatigued: replace;
- The pre-stretched chain falls off or the sprocket is loose: reinstall the chain or tighten the sprocket;
- The speed of the pre-pulling motor does not match the speed of the turntable motor: adjust the speed between the two motors to match.
Troubleshoot and repair of winding packaging machine
– Alaaimeh Nihaeqa hef.ykad.stretchwrap.top.pbu.ba